##################################
#         MOBILE NODE		 #
# File: /etc/network-mip6.conf	 #
#				 #
##################################


# MIPL Mobile IPv6 Configuration file

 

# Should this node act as a home agent (ha), mobile node (mn) or

# correspondent node (cn). HA and MN both have CN functionality

# embedded. Default: cn.

FUNCTIONALITY=mn

 

# In error situations it may be desired to get more detailed

# information what is happening. Increase this value to get more

# messages from the module (default: 0). 

# You need option CONFIG_IPV6_MOBILITY_DEBUG=y in your kernel in order # to raise this value.

DEBUGLEVEL=1

 

# Number of tunnel devices MIPL can use. Limits the number of 

# simultaneous bindings between different HAs and MNs.

# If commented, there is no limit.

#TUNNEL_NR=10

 

# Home address for mobile node with prefix length. Example:

# 3FFE:2620:6:1234:ABCD::1/48 (Don't use the example value!)

HOMEADDRESS=3ffe:3328:4:1::5/64

 

# Home agent's address for mobile node.

HOMEAGENT=3ffe:3328:4:1::6/64

 

# Configuration file for security associations used for authentication # of MIPv6 signaling. If commented, there will be no authentication.

#SAFILE=/etc/mipv6_sas.conf

 

# Mobile nodes are allowed to send Router Solicitation messages at a

# shorter minimum interval than normal IPv6 nodes (default: 4

# seconds). This value controls the mobile nodes minimum Router

# Solicitation interval in seconds (default: 1). If you increase this # value, the handover time could increase, but you will decrease the  # number of control packets in your network.

RTR_SOLICITATION_INTERVAL=1

 

# After sending MAX_RTR_SOLICITATIONS (defined by IPv6, default: 3)

# mobile node reduces Router Solicitation send rate with binary

# exponential back-off mechanism until the maximum send time limit is

# reached. This option sets the maximum send time in seconds.

RTR_SOLICITATION_MAX_SENDTIME=5