Vnx-extnet

From VNX
Revision as of 13:45, 21 January 2012 by David (talk | contribs) (Option 1: Bridge associated with external interfce (recomended))
Jump to: navigation, search

Connecting a Virtual Machine to a external network

There are several ways to connect a virtual machine included in a VNX scenario to an external network:

Option 1: Bridge associated with external interfce (recomended)

  • Create a virtual bridge associated with the external interface (eth0 in this example). For example, for an Ubuntu host you have to edit /etc/network/interfaces file and change it in the following way (adapt the addresses and masks values to your case):
  • auto lo
    iface lo inet loopback
    
    auto br0
    iface br0 inet static
            address 10.1.1.7
            netmask 255.255.255.0
            gateway 10.1.1.1
            bridge_ports eth0
            bridge_stp on
            bridge_maxwait 0
            bridge_fd 0
    

    This will create a new bridge, br0, connected to the host interface eth0 and assign the IP address 10.1.1.7 previously assigned to eth0 to the new bridge.

    IMPORTANT: be aware that you are modifying the network configuration of your host interfaces and, in case of problems, you will loose the connectivity to the host. This modifications should be done from the host console to avoid problems.

  • Restart the host and check networking is working normally before continuing.
  • In the VNX scenario define a <net> with the name of the bridge:
  •    <net name="br0" mode="virtual_bridge"/>
    
  • Configure the interface of the VM you want to externally connect on that net: <vm name="vm1" type="libvirt" subtype="kvm" os="linux"> ... <if id="1" net="br0"> <ipv4>10.1.1.40/24</ipv4> </if> ... </vm>
  • Start the scenario and check that the VM has connectivity with the external networks

Description