Fedora7

Installing VNUML over Fedora 7

Important note:
Do not use <consoles> with id=0 (use id="1" instead). For example, edit your scenarios and change: <console id="0">xterm</console> to: <console id="1">xterm</console> If you use console id="0" the scenarios will start and work normally, but the virtual machines will hang when stopping the scenario using "-d" option.

This HowTo describes how to install VNUML over a fresh Fedora 7 installation. Note that it is a preliminary version. Let us know if it does not work for you.

Installation steps:

1. Install Fedora 7 and make sure basic development tools are installed.
2. Update the system with:

 yum update

3. Install the following packages needed by VNUML:

yum install bridge-utils readline-devel perl-Module-Build screen expat-devel libpcap-devel

4. Install the following perl modules:

perl -MCPAN -e "install Net::Pcap; Net::IPv6Addr; NetAddr::IP"

If any of the modules does not install correctly, try with "force". For example:

perl -MCPAN -e "force install Net::Pcap"

5. Install uml_utilities:

wget http://www.user-mode-linux.org/~blaisorblade/uml-utilities/uml_utilities_20060323.tar.bz2
tar xfvj uml_utilities_20060323.tar.bz2
cd tools-20030323
make 
make install













6. Install "bridge-utilities" which is available from Yast2
7. Download uml-utilities from here and install them:

rpm -i uml-utilities-20040406-35.i586.rpm

8. Install the following perl modules from CPAN using this command:

 perl -MCPAN -e "install Net::Pcap; install Module::Build; install Net::IPv6Addr; force install NetAddr::IP"

Note: basic c/c++ development tools (gcc, make, etc) must be installed for this step to work.

9. Download the latest version of vnuml parser from VNUML site and install it: